How Long a Wheelchair Ramp for 24 Inches of Rise?

A 24 inch rise needs a 24 ft wheelchair ramp at 1:12, the steepest slope the ADA allows: 1 foot of ramp for every inch of rise. It is built as one run, with no landing part way up, and takes up 29 ft with the 5 ft landing at the top. At 1:16 the ramp is 32 ft, and at 1:20 it is 40 ft.

Jump to your result ↓

Results

Example job shown. Change the numbers to match yours.

Ramp length (horizontal run)

24.0 ft

1 inch of rise needs 12 inches of ramp. Measure this along the ground, not along the sloping surface

What to buy

Decking, with 10% extra172 lineal ft of boards, rounded up
Joists per run (16 in centers)4 joists
Joist lumber (size from a span table), with 10% extra106 lineal ft of lumber, rounded up
80 lb bags of concrete mix for those landings (0.6 ft³ each)16 bags

Walking surface length (along the slope): 24.1 ft
Separate ramp runsEach run climbs no more than 30 in: 1 run
Intermediate landings (5 × 5 ft): 0 landings
Landings in total (5 ft × 5 ft clear space at each)1 top + 0 intermediate + 1 clear space at the bottom. The concrete and bag counts below cover the top and intermediate landing (1), not the bottom one: 2 landings
Total footprint with a 5 ft top landing: 29.0 ft
Footprint with the 5 ft clear space at the bottom as wellThe bottom 5 ft is level ground or a landing you pour or lay separately: it is not in the concrete below: 34.0 ft

Materials (wood ramp runs, concrete landings)

Deck boards (5/4×6, laid across the ramp)Each row is one board 3.0 ft long: 52 board rows
Concrete for the top landing (1 at 5 ft × 5.0 ft, 4 in thick, +10%): 9.2 ft³
Same concrete in cubic yards: 0.34 yd³

Requirements to check

Handrails needed (rise over 6 in): Yes, both sides
Handrail length, both sides, with 12 in extensionsEach side: the walking surface length plus 12 in at the top and bottom of every run (ADA Standards 405.8 and 505.10.1). Rail stock, posts and brackets are extra: 53 lineal ft
Clear width: 36 in

Size the joists for their span from a span table or your plans examiner.
Under the ADA, the maximum slope is 1:12, the maximum rise of one run is 30 inches, landings must be at least 60 inches long and as wide as the ramp, and the clear width must be at least 36 inches. Residential rules differ by place, so check local codes, and allow 5 ft of clear space at the bottom. The materials list is a planning estimate for a wood-framed ramp with a concrete top landing and any intermediate landings: the concrete covers the top and intermediate landings only, not the level 5 ft at the bottom. It leaves out posts, footings and guards (the handrail length is given above), whose spacing and size depend on your loads, frost depth and local code.

Before you buy: round up to whole packs, check the size printed on the label, and add a little spare. Your supplier has the final say.

Blueprint

24 ft ramp

Twenty-four inches: the usual porch height

A 24 inch rise is what the ramp calculator opens on. At 1:12 it is 24 ft of ramp in one run and 29 ft with the top landing. The walking surface measures 24.08 ft along the slope, only 1.0 inches more than the run.

If there is room, the same rise at 1:16 is 32 ft and at 1:20 it is 40 ft. Those gentler ramps are 8 ft and 16 ft longer, and much easier to climb in a manual chair.

24 inch rise at each slope

Slope	Ramp length (run)	Along the surface	Percent	Angle	Runs	Footprint with landings
1:12 (ADA maximum)	24 ft	24.08 ft	8.3%	4.8°	1	29 ft
1:16	32 ft	32.06 ft	6.3%	3.6°	1	37 ft
1:20	40 ft	40.05 ft	5.0%	2.9°	1	45 ft

The footprint adds a 5 ft landing at the top. Allow 5 ft of clear, level space at the bottom too: with it the 1:12 ramp needs 34 ft from end to end. That bottom space is not in the concrete estimate below.

Is my ramp too steep for 24 inches?

Slope is rise ÷ run. For a 24 inch rise, a ramp shorter than 24 ft is steeper than 1:12:

Ramp length	Slope	Percent	Angle	Within 1:12?
20 ft	1:10	10.0%	5.7°	No, 4 ft too short
22 ft	1:11	9.1%	5.2°	No, 2 ft too short
24 ft	1:12	8.3%	4.8°	Yes
28 ft	1:14	7.1%	4.1°	Yes

Materials for the 24 ft ramp

A wood ramp 24 ft long and 36 inches wide takes 52 rows of 5/4×6 deck boards laid across it, 172 lineal feet with 10% extra, on 4 joists per run at 16 inch centers (106 lineal feet). The 4 inch concrete for the top landing is 0.34 cubic yards, about 16 bags of 80 lb mix. Built 48 inches wide, the decking rises to 229 lineal feet on the same 4 joists per run. Handrails on both sides, with a 12 inch level extension at the top and bottom of the run, come to 53 lineal feet of rail. Posts, brackets and footings are not in these figures.

Ramp length for nearby rises

Rise	1:12	1:16	1:20	Runs	Footprint at 1:12
20 in	20 ft	26.67 ft	33.33 ft	1	25 ft
22 in	22 ft	29.33 ft	36.67 ft	1	27 ft
24 in	24 ft	32 ft	40 ft	1	29 ft
28 in	28 ft	37.33 ft	46.67 ft	1	33 ft
30 in	30 ft	40 ft	50 ft	1	35 ft

Coming down steps instead of a measured height? See a ramp for 3 steps or a ramp for 4 steps, or read the ramp length and slope guide.

Want to change anything else? The calculator above is the full Wheelchair Ramp Calculator: edit any number and the results update instantly.

Tools & materials for this project

Affiliate links As an Amazon Associate we earn from qualifying purchases. These links do not change what you pay.

Portable folding ramp

Frequently asked questions

How long does a wheelchair ramp need to be for a 24 inch rise?

24 ft at the 1:12 maximum slope, because every inch of rise needs 12 inches of ramp. With the landings it takes up 29 ft. At 1:16 the ramp is 32 ft and at 1:20 it is 40 ft.

Is a 20 foot ramp OK for a 24 inch rise?

No. 24 inches over 20 feet is 1:10, a 10.0% slope at 5.7°, steeper than the 1:12 (8.3%) maximum. It is 4 ft too short.

What is the slope of a 24 ft ramp with a 24 inch rise?

1:12, which is 8.3% or 4.8 degrees. Divide the rise by the run in the same unit: 24 ÷ 288 inches = 0.0833.

Related sizes and guides

Estimates only. Results assume standard materials and simple shapes. Supplier products vary, and the final call on quantity, structure and safety is yours. Check your local code and your supplier's guidance before ordering.

Your project