How Many Gallons in a 16x32 Pool?

A 16 × 32 ft rectangular pool holds about 19,150 gallons at a 5 ft average depth, and 15,320 gallons at 4 ft. Find your own average depth, then use the table or the calculator.

Jump to your result ↓

Your project

The 8 is an example for an in-ground pool with a deep end; a round pool ignores it until you type your own. For an above-ground pool or any flat bottom, clear the box (or enter 0) and put the water depth in the shallow end box.

gal/min

A garden hose delivers about 5 to 10 gallons a minute.

Results

Example job shown. Change the numbers to match yours.

Pool volume
19,150 US gallons
Flat floor: the deep end is the same as the shallow end
Liters
72,491 L
Cubic feet
2,560 ft³
Water surface area
512 ft²
Average depth
5.00 ft

Filling

Time to fill with a hose (hours)
35.5 hours
Time to fill with a hose (days)
1.5 days
  • Volume = surface area × average depth × 7.48 gallons per cubic foot. Oval pools use 0.7854 (π ÷ 4) times a rectangle of the same length and width. Kidney pools use the trade rule of thumb area = (A + B) × length × 0.45, good to roughly 5 to 10%. Other freeform pools are harder to estimate: use the average of several measurements.

Blueprint

16 ft32 ft

19,150 gallons

Gallons in a 16 × 32 ft pool, by average depth

For a pool with a sloping floor, find the average depth first: (shallow end + deep end) ÷ 2. The surface area is 512 ft². The fill time is for a hose delivering 9 gallons per minute.

Average depthGallonsLitersHose fill time
3.5 ft13,40550,74424.8 hrs
4 ft15,32057,99328.4 hrs
4.5 ft17,23565,24231.9 hrs
5 ft19,15072,49135.5 hrs
5.5 ft21,06579,74039.0 hrs
6 ft22,98086,98942.6 hrs

Why you need the number

Pool chemical doses are given per number of gallons, and pumps, filters and heaters are sized to the volume. Measure the actual water depth in your own pool and follow the label on any product you add.

Water weight, pump size and fill cost

At 19,150 gallons, this pool holds about 159,712 lb of water (79.9 tons). That is a lot of weight on one patch of ground, which is why the base must be level and well compacted before you fill it.

To turn the whole volume over through the filter in 8 hours, the pump and filter need to move at least 39.9 gallons per minute (53.2 GPM for a 6-hour turnover). If a chemical label gives a dose per 10,000 gallons, multiply it by 1.92 for this pool.

Water price per 1,000 galCost to fill
$4$77
$6$115
$8$153

Water prices vary a lot, and some utilities charge a separate sewer rate that does not apply to a pool. Check your own bill.

A 16 × 32 ft pool: a full-size residential pool

A 16 × 32 ft rectangular pool holds 19,150 gallons at a 5 ft average depth, 15,320 at 4 ft, with a surface of 512 sq ft. This is a common size for a residential in-ground pool, and the figure is the starting point for sizing equipment and chemicals.

At this volume, the heater is the big decision. Gas heaters, heat pumps and solar all work, but the output must be chosen for the number of gallons and the temperature rise you want. Because 19,150 gallons weigh around 159,712 lb, a cover is also worth having to cut evaporation and keep the heat in. Allow 35.5 hours to fill from a hose.

Cover size and the deck around it

The water surface is 512 sq ft. A safety cover is cut larger than the water, and a margin of about 1 ft on every side is common, which for this pool would mean a cover of roughly 612 sq ft. The maker's measuring guide decides the real size, so give them the pool's measurements rather than relying on this figure. A solar blanket or a cover on the surface also slows evaporation and heat loss, and the surface area sets the size of both.

A 3 ft wide deck all the way round adds 324 sq ft, an overall 22 × 38 ft less the pool. At 4 in thick that is about 4.0 cu yd of concrete before waste. The pool surface area calculator works out the surface, deck and liner areas for other pool shapes.

Want to change anything else? The calculator above is the full Pool Volume Calculator: edit any number and the results update instantly.

Tools & materials for this project

Affiliate links As an Amazon Associate we earn from qualifying purchases. These links do not change what you pay.

Frequently asked questions

How many gallons in a 16x32 pool?

It depends on the average depth: about 15,320 gallons at 4 ft, 19,150 at 5 ft and 22,980 at 6 ft. For a sloping bottom, use the average of the shallow and deep ends.

How do I find the average depth of a 16x32 pool?

Add the depth at the shallow end to the depth at the deep end and divide by two. A pool that is 3½ ft at one end and 8 ft at the other averages 5¾ ft, which holds 22,023 gallons at this size.

How long to fill a 16x32 pool with a hose?

At 9 gallons per minute, a 16x32 pool with a 5 ft average depth takes about 35 hours (1.5 days). Many owners have water delivered for pools this size.

Related sizes and guides

Estimates only. Results assume standard materials and simple shapes. Supplier products vary, and the final call on quantity, structure and safety is yours. Check your local code and your supplier's guidance before ordering.